Design a Scaffold Using the Bay Tool

1. Open the Bay Tool and set the required bay height and configuration.
2. Create bay lines around the building:
   • Extend each bay slightly past the building corners.
   • Allow enough overlap for the adjoining bays to be connected.
   • Adjust individual bay lengths where required.
3. Connect standard corners using the Lapping Bay Tool:
   • Select the two adjoining bays.
   • Create the lap.
   • Review the automatically generated planks, tubes and couplers.
4. Add Edge Protection:
   • Select the required bay.
   • Use Get to load its current properties.
   • Identify End 1 or End 2 using the labels if required.
   • Set the required end to Closed and click Modify.
5. For sharp or irregular corners:
   • Use Tube & Clip to connect the standards.
   • Use the Item Tool to add steel or timber planks across the corner.
   • Copy the components to the required lifts.
6. To modify multiple bays:
   • Select the required bays and open the Bay Tool.
   • Untick all properties that should remain unchanged.
   • Enable only the property you want to modify, such as Bracing or Bay Height.
   • Click Modify.
7. Always use Get before modifying an individual bay to load its current settings and avoid unintentionally changing other properties.

For more info please review - Tube and Fitting Overview